Your pool deck takes more abuse than almost any other surface on your property. We pour pool decks in Mission that grip wet feet, drain heavy rains, and hold up through years of intense South Texas sun.
Concrete pool decks in Mission require proper base compaction for local clay soil, positive drainage away from the pool and house, and a non-slip finish chosen for South Texas heat - most residential projects take two to five days from start to finish, with light foot traffic possible within 48 hours of the pour.
Pool decks in this area fail for a predictable reason: the Hidalgo County clay soil shifts with every rain cycle, and a contractor who does not account for that builds a deck that cracks within a few years. In Mission, the deck also has to handle afternoon storms that can drop two inches of rain in an hour - so drainage design is not a detail, it is the difference between a dry deck and one that floods toward your foundation. We also handle related outdoor surfaces like concrete steps and concrete patios, so your entire outdoor living area can be built and finished to match.
Whether you are building a new pool and need the deck to go in right the first time, or you are replacing a surface that has cracked and faded, call us to talk through your options. We will tell you exactly what the job requires and give you a written estimate before any work begins.
If you have patched cracks in your pool deck before and they keep reappearing in the same spots, the problem is in the soil underneath - not just the surface. In Mission, the clay-heavy ground swells and shrinks with the wet and dry seasons, and that movement will keep breaking surface patches until the underlying issue is addressed. A new deck with a properly prepared base is often the more cost-effective long-term solution.
If the surface feels slick underfoot after splashing, the texture has worn down to the point where it is no longer safe. This is especially common on older decks that were never sealed or that have been exposed to years of Mission's intense sun. A resurfaced or replaced deck with a proper non-slip finish solves this problem permanently and is worth doing before someone gets hurt.
Standing water on a pool deck is a sign that the surface is no longer draining correctly - either because it has settled unevenly or because the original slope was inadequate. In Mission, where summer storms can be intense, a deck that holds water creates a slip hazard and can push moisture toward your foundation over time. Poor drainage after a storm is a warning sign worth acting on now.
Mission's UV intensity is hard on concrete surfaces. If your deck has gone from a rich color to a washed-out, chalky appearance, the protective sealer has failed and the surface is being degraded by sun exposure. Left unaddressed, this leads to surface erosion and eventually structural cracking - catching it at the cosmetic stage is much cheaper than waiting until the surface breaks apart.
Every pool deck project starts with ground preparation. We compact the base, address soft spots, and slope the subgrade before any forms go in. Then we pour, level, and finish the surface with your chosen texture - broom finish for maximum grip and value, or stamped and colored options for homeowners who want their outdoor space to look intentional. We cut control joints to manage how the concrete expands in Mission's heat, and we apply a UV-rated sealer as part of every job. Where the deck connects to concrete steps or an adjacent patio, we can pour them together so the finished surfaces match in height, color, and texture. City of Mission permit applications and inspection coordination are handled for you.
We give you a written estimate before work starts and walk you through the finished deck before we leave. You will know what to expect during curing, when it is safe to resume pool use, and how to maintain the surface so it holds up through years of South Texas weather.
Suits new pool builds or pools that never had a proper surrounding surface. We design the layout, drainage slope, and finish from scratch to match your yard and pool shape.
Suits homeowners with cracked, sunken, or drainage-failing decks. We remove the old surface, address what caused it to fail, and pour a replacement built on a properly prepared base.
Suits homeowners who want a durable, non-slip surface at a practical price point. Broom finish is the most common pool deck finish in Mission for good reason - it performs well in heat and wet conditions.
Suits homeowners who want a backyard that looks as good as it functions. Stamped patterns and integral color turn a standard deck into a design feature while keeping the non-slip texture your pool area needs.
Mission sits in the Lower Rio Grande Valley, where summer temperatures regularly exceed 100 degrees and UV exposure is among the most intense in the continental United States. Those conditions break down unsealed concrete surfaces faster than almost anywhere else - fading color, drying out the surface, and eventually causing small cracks that grow. For pool deck work in Mission, the finish and sealer your contractor chooses matter as much as the pour itself. Homeowners in McAllen and Pharr face the same climate and soil conditions, and we bring that same regional experience to every project across the Valley.
The clay soil found throughout Hidalgo County is the other factor that sets this area apart. It swells when rain soaks it and shrinks when drought dries it out - and that constant cycle is what causes pool decks in Mission to crack at a higher rate than in areas with more stable soil. Contractors who learned their trade elsewhere often skip the base prep steps that this soil demands. We have poured pool decks all over Mission, from the older neighborhoods near downtown to the newer subdivisions on the north side, and we build every deck with local conditions in mind from the first step. The National Swimming Pool Foundation recommends non-slip texture and positive drainage as baseline standards for every pool deck - we treat those as the starting point, not the finish line.
We will ask a few basic questions - pool size, existing deck condition, and finish preferences. This is not a commitment; it helps us prepare for the on-site visit. We reply within one business day.
We come to your home, measure the area, assess drainage and soil conditions, and walk through finish options with you. You receive a written estimate that clearly states what is included - no surprise add-ons after the job starts.
If the City of Mission requires a permit for your project, we handle the application. Once permits are in hand, we schedule your start date and arrive ready to grade, compact, and form the deck area - the groundwork that makes everything else last.
We pour early in the day to manage Mission's heat, finish the surface with your chosen texture, and apply a UV-rated sealer once the concrete has cured. Before we leave, we walk the finished deck with you and give you a clear timeline for when the pool area is ready for normal use - typically about a week.
Free written estimate. No high-pressure sales. We will come to your home, measure the space, and tell you exactly what the job involves.
(956) 833-0052Hidalgo County clay is one of the most expansive soil types in Texas - it is the root cause of most pool deck cracking in Mission. We compact the base and address drainage before every pour, so your deck does not end up cracked and sloping within a few years of installation.
Mission gets some of the most intense UV exposure in the continental United States. We apply a sealer rated for high UV environments as part of every pool deck job, not as an upsell. That one step extends the life of your finish by years and keeps the surface from fading and chalking out prematurely.
Every project starts with a written estimate that spells out what is included - demolition, permit fees, finish, and sealing. We do not quote a low number and then add charges once the job is underway. What you approve is what you pay.
We work across 12 service areas in the Rio Grande Valley, which means we have poured pool decks in Mission neighborhoods from the older established streets near downtown to the newer subdivisions on the north side. That regional depth shows in how we prepare for local soil and weather conditions on every job. The American Concrete Institute sets the professional standards we build to.
South Texas pool decks need more than a straight pour - they need a contractor who understands what this specific soil, heat, and rain environment does to concrete over time. That local knowledge is the difference between a deck that lasts a decade and one that lasts three.
Add safe, properly pitched entry or pool-side steps that connect to your new deck without a gap or height mismatch.
Learn more about Concrete steps constructionExtend your outdoor living space beyond the pool edge with a connected patio poured on the same stable base.
Learn more about Concrete patio constructionPool season fills our calendar fast - reach out now to lock in your project date before the summer rush.
